When sawing a long piece of material or a panel, always use a work support.Turn the switch off, allow the blade to stop, raise the anti-kickback teeth on each side of the riving knife if necessary and slide the workpiece out. Never try to pull the workpiece back with the blade turning.Continue pushing the workpiece until it is clear of the blade guard assembly and it falls off the rear of the table. Keeping the workpiece against the table and fence, slowly feed the workpiece rearward all the way through the saw blade.Always keep your thumb along side your first two fingers and near the fence. When there i s approximately 12" (305 mm) left to be ripped, use only one hand, with your thumb pushing the material, your index and second finger holding the material down and your other fingers hooked over the fence. Both hands can be used in starting the cut. Turn the saw on and allow the blade to come up to speed.Keep the workpiece about 1" (25.4 mm) away from the blade Hold the workpiece flat on the table and against the fence.Raise the blade so it is about 1/8" (3.2 mm) higher than the top of the workpiece.Lock the rip fence by pressing the rail lock lever down.Push down on guard(s) and they will release to the operating position.This feature increases visability when measuring the blade to fence distance.The guard(s) will lock in place when in the raised position.INSTRUCTION MANUAL Compact Job Site Table Saw Dewalt DWE7480 Dewalt DWE7480 - Use Manual - Use Guide PDF.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |